ZZ9000 Hardware details
Panoramica ZZ9000La regina delle Schede Video Amiga !
Panoramica ZZ9000La regina delle Schede Video Amiga !
ZZ9000 vista lato connettori ADa sinistra a destra HDMI, porta LAN, Porta USB e slot MicroSD
ZZ9000 vista lato connettori BDa sinistra a destra slot MicroSD, Porta USB, Porta LAN e HDMI
Disallineamento della Scheda 2
Disallineamento della Scheda 1
Disallineamento della Scheda 3
Disallineamento della Scheda 4
ZZ9000 Flat to Video Slot
Vista Connettori ZZ9000
WorkBench Amiga on OS 3.1.4.1 at 1920 x 1080 x 16bit
Specifications of ZZ9000
FPGA-based graphics: One 200 MHz Xilinx ZYNQ 7-series XC7Z020 chip
ARM Cortex-A9 processors: Two 32-bit, 666 MHz cores
Graphics output: One HDMI port - DVI via non-HDMI compliant HDMI connector, with SiliconImage 9022 encoder)
Memory: 1 GB of DDR3 RAM
Networking: One Gigabit Ethernet port - using Micrel KSZ9031 PHY
Firmware storage: One microSD port that is not AmigaOS accessible; supporting microSD cards from 128 MB to at least 32 GB. The official maximum supported capacity is currently unknown.
USB Connectivity: One USB v2.0 port - zzusb.device/ZZ0: in the ZZ9000 ROM and mass storage only (firmware v1.9+) and no hotplug yet. Be sure to insert USB stick before starting/resetting Amiga; requires stable 1.9 or higher drivers)
Native Amiga (scandoubled/flicker-fixed) video throughput: One ZZ9000CX video slot capture card with ribbon cable (34-pin 2.54 mm-pitch Female/Female 34-wire IDC Flat Ribbon Cable) - Zorro II cable length: 55 cm (21.6 in.) - Zorro III cable length: 10 cm (3.9 in.)